![]()
I’ve also read some interesting threads touting the advantages of the ISY-99 controller. Addressing basic network programming is OK, but if it’s situation where I need to be a network programmer to configure my panel, I’ll need some assistance. I've also read threads that say that it can be accessed from outside my LAN? I’m not a network expert, but I do have a basic understanding of networking. I’ve also read comments that indicate that the M1 can only be accessed from my own internal LAN, rather than from anywhere in the world. It seems as though setting up the email capability of the M1 is a real challenge. However, I’ve been reading many threads here that are making me re-consider. My original plan was to buy an M1 with the M1XEP module. My intent is to have a system that I can log into while traveling, and that will send me emails when there is a problem. I currently have DSL service in my home with a small wireless router. I also want the capability to have the panel send me emails upon certain events. Some of the features that I want in my new control panel are the ability to program and check status via the Internet, from anywhere in the world. #ELK M1 ETHERNET MODULE ACTIVETCL SERIES#The alarm panel functions and the telephone dialing are items that I am very familiar with as I spent over 20 years installing Radionics/Bosch series 8112 & 7400 series control panels. Some of the features that I see in the M1 that I need are 16 on board inputs, custom voice messages based upon events, event logger, multiple outputs, etc. ![]() I expect that to become more of an issue when I have a more sophisticated panel. I have a few X-10 modules for basic lights on/off type of stuff. At this point I have little in the way of home automation. I am recently retired and I expect to be traveling a lot more so I’m hoping this new system will give me some piece of mind while I’m gone by monitoring my sump pump pit, home temperature, status of my standby automatic generator, etc. My primary need is for a new alarm panel, but I’m leaning towards the Elk due to its automation/controller capabilities. I am hoping you can help me out on a few issues/concerns that I have. There appears to be a wealth of info here, with some qualified members. I discovered this site while doing Google searches for info and feedback on the M1 panel. ![]() All other devices must use the “Elk C1M1” driver.I’ve been considering upgrading my home alarm system to an Elk M1 for a couple of months. ![]() However, only a single device can do so reliably. #ELK M1 ETHERNET MODULE ACTIVETCL DRIVER#When configuring the device driver in eKeypad, it is possible to use the “Elk XEP” driver in eKeypad to connect to an ELK-C1M1 via the unencrypted port. This M1-XEP module supports approximately 15-30 simultaneous connections depending on how it is setup. The ELK-C1M1 module is limited to only one connection at a time. The root of the issue is related to how the two module support unencrypted, local network connections. There are a number of stability and reliability risks which need to be fully understood. Using an ELk-C1M1 module can work, but the setup is much more complex. We strongly recommend using the M1-XEP module for these scenarios. #ELK M1 ETHERNET MODULE ACTIVETCL FULL#This is an important concern when using dedicated, full time eKeypad stations onsite. Both local network ethernet and cellular (via ElkLink) connectivity. Only local network ethernet connectivity. ![]() The Elk M1 alarm panel has two options for network connectivity. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |